Overhead Crane Operator & Rigging Train-the-Trainer Refresher Webinar (3-days)
PRE-REQUISITE: 808T, 808TR, 808TW or 808TRA completed within the last two (2) years
This course is a 3-day refresher course for previously certified operator trainers from Konecranes. This course will use either the Cab and Floor Crane Operator Course #808 or the Floor Crane Operator Course #808A as desired.
These courses cover all the OSHA/ASME requirements for overhead crane operation including the reasons behind the requirements. They begin with the fundamentals such as identification of major crane components and focuses on the safe and proper operation of the crane.
Nucor Steel Terry P.
What I liked most about the seminar was…) The instructor and PowerPoints
Sonora Equip. Kirk G.
(What I liked most about the seminar was…..) Listening and watching other people's demonstrations.
General Motors Bryan L.
Student & instructor interaction encouraged. Picked up valuable information from others experiences
Precise Tool David L.
(What I liked most about the seminar was…) Small classroom, well organized.
Nucor Steel Rusty B.
(What I liked most about the seminar was…) Talking everyone about similar
problems and answers that they have had luck with.
Crane Course for Operator and Rigging Training Personnel
Do you have so many operators within your facility that having an outside contractor come in to conduct all the operator training is not cost effective? Using an experienced operator to conduct training is a common practice in industry. Will that individual pass on any bad habits in the process?
Think back to your state sponsored road test for your driver’s license, do you still drive a motor vehicle as you did for the state examiner? Most people would have to say no. Habits both good and bad become a part of our day to day lives before we are even aware of them.
This crane course will give the potential trainers not only the requisite information but also instructional skills for presenting information before groups of people.
This overhead crane operator training course will use either the Cab and Floor Crane Operator Course #808 or the Floor Crane Operator Course #808A as desired.
These crane training courses cover all the OSHA/ASME requirements for overhead crane operation including the reasons behind the requirements. We begin with the fundamentals such as identification of major crane components and focuses on the safe and proper operation of the crane.
- Identify all major crane components
- Explain the function of major components
- Explain and use recommended hand signals
- Explain and apply all recommended safety procedures
- Perform all recommended operating procedures
- Correctly make precision lifts
- Understand crane control operations (AC or DC)
- Hands-on training
- Major crane components
- Safety devices
- Recommended operating procedures
- Safe operating practices
- Conduct a 20-minute training presentation
You will receive the following (Student Kit):
- (12) Workbooks
- (12) OSHA Guides
- (12) Rigging Handbooks
- (12) Pocket Safety Tips
- (12) Safety Recommendations
- Certificate of Training
Contact the Konecranes Crane Training Institute now for questions or special requests.