You are here

Houston, TX

Konecranes Training Institute will be conducting the following courses:

Location:

Konecranes Office

7300 Chippewa Blvd.
Houston , TX
United States
Texas US

Courses in this location

E.g., August 11,2020
E.g., August 11,2020
August 11,2020

This 2-day crane training is a must for Mobile Crane Operators at your plant site. After completing this crane operator training, students will have an understanding of safe operating practices, the top causes of Mobile Crane Accidents and how to prevent them.

You will receive: Load Charts & Course Workbook

Category: Mobile Cranes
August 12,2020

This important, 2-day mobile crane inspector training will give students an understanding of the requirements for inspections, importance of inspections, and how to inspect cranes safely meeting requirements of OSHA and ASME B30.5

Category: Mobile Cranes
September 8,2020

This 3-day rigging training provides participants with the best methods for conducting training of crane operators and rigging personnel.

Category: Rigging
September 9,2020

This 1-day rigging training gives students the knowledge on safe rigging practices, rigging terminology, good and bad rigging practices and more.

Category: Rigging
September 9,2020

This 2-day rigging training course is for people with prior rigging experience.

Category: Rigging
October 13,2020

This 3-day overhead crane operator training course is highly recommended for Internal trainers and facility crane experts. This crane course covers all the OSHA/ASME requirements for overhead crane operation including the reasons behind the requirements.

Category: Operation
October 13,2020

PRE-REQUISITE: 808T, 808TR or 808TRA completed within the last two (3) years

This course is a 3 day refresher course for previously certified operator trainers from Konecranes. This course will use either the Cab and Floor Crane Operator Course #808 or the Floor Crane Operator Course #808A as desired.

These courses cover all the OSHA/ASME requirements for overhead crane operation including the reasons behind the requirements. They begin with the fundamentals such as identification of major crane components and focuses on the safe and proper operation of the crane.

Category: Operation
November 10,2020

This popular crane inspection course covers a wide variety of crane configurations. Participants receive a working knowledge of all pertinent regulatory agency requirements.

Category: Inspection
November 10,2020

PRE-REQUISITE:  818, 819, or 820 taken within the last 2 years.  

819R is a 3 day refresher for those who have completed the 818, 819, or 820 course in the past and wish to keep their Inspection Certificate current. 

Category: Inspection
December 8,2020

This 2-day electrical crane maintenance training course highlights electrical maintenance procedures for all types of A.C. crane controls including A.C. full magnetic, stepless and adjustable frequency drives and is considered the basic orientation to electrical maintenance.

Category: Maintenance

Pages

Content bottom