You are here

Overhead Crane Operator & Rigging Train-the-Trainer (Refresher) - 3 Days

Course number: 808TR
Length: 3 days
Price: $1225.00
Category: Operation

PRE-REQUISITE: 808T, 808TR or 808TRA completed within the last two (3) years

This course is a 3 day refresher course for previously certified operator trainers from Konecranes. This course will use either the Cab and Floor Crane Operator Course #808 or the Floor Crane Operator Course #808A as desired.

These courses cover all the OSHA/ASME requirements for overhead crane operation including the reasons behind the requirements. They begin with the fundamentals such as identification of major crane components and focuses on the safe and proper operation of the crane.

Milwaukee Konecranes Training Institute
December 3,2019

Really enjoyed the class and (the instructor) did an outstanding job. I hope to be
able to attend many more classes here.

Nucor Steel Robert S.

(What I liked most about the seminar was…..) Practical experiences that the instructor had to offer.

General Motors Tim Petty

(What I liked most about the seminar was…..) Instructor was very knowledgeable.

Los Alamos Ted L.

The way (The Instructor) explained the course.

Kinder Morgan Mike S.

(What I liked most about the seminar was...) The attention and courtesy of instructor.

Toro Cano B.

Crane Course for Operator and Rigging Training Personnel

Do you have so many operators within your facility that having an outside contractor come in to conduct all the operator training is not cost effective? Using an experienced operator to conduct training is a common practice in industry. Will that individual pass on any bad habits in the process?

Think back to your state sponsored road test for your driver’s license, do you still drive a motor vehicle as you did for the state examiner? Most people would have to say no. Habits both good and bad become a part of our day to day lives before we are even aware of them.

This crane course will give the potential trainers not only the requisite information but also instructional skills for presenting information before groups of people.

This overhead crane operator training course will use either the Cab and Floor Crane Operator Course #808 or the Floor Crane Operator Course #808A as desired.

These crane training courses cover all the OSHA/ASME requirements for overhead crane operation including the reasons behind the requirements. We begin with the fundamentals such as identification of major crane components and focuses on the safe and proper operation of the crane.

Course objectives

  • Identify all major crane components
  • Explain the function of major components
  • Explain and use recommended hand signals
  • Explain and apply all recommended safety procedures
  • Perform all recommended operating procedures
  • Correctly make precision lifts
  • Understand crane control operations (AC or DC) - Rigging 800T course is also included
  • Hands-on training

Course outline

  • Major crane components
  • Safety devices
  • Recommended operating procedures
  • Communications
  • Safe operating practices
  • Conduct a 20-minute training presentation

You will receive the following (Student Kit):

  • (12) Workbooks
  • (12) OSHA Guides
  • (12) Rigging Handbooks
  • (12) Pocket Safety Tips
  • (12) Safety Recommendations
  • Certificate of Training

Contact the Konecranes Crane Training Institute now for questions or special requests.

Register Online

Dayton, OH Area

December 9,2019
Register Online

Philadelphia, PA

December 10,2019
Register Online

Mobile, AL

December 17,2019
Register Online

Pittsburgh, PA

December 17,2019
Register Online

Milwaukee Konecranes Training Institute

January 14,2020
Register Online

Philadelphia, PA

January 14,2020
Register Online

Phoenix, AZ

January 21,2020
Register Online

Springfield, OH

January 21,2020
Register Online
Content bottom