Overhead Crane Operator & Rigging Train-the-Trainer (Refresher) - 3 Days
PRE-REQUISITE: 808T, 808TR or 808TRA completed within the last two (2) years
This course is a 3 day refresher course for previously certified operator trainers from Konecranes. This course will use either the Cab and Floor Crane Operator Course #808 or the Floor Crane Operator Course #808A as desired.
These courses cover all the OSHA/ASME requirements for overhead crane operation including the reasons behind the requirements. They begin with the fundamentals such as identification of major crane components and focuses on the safe and proper operation of the crane.
Trane Clayton P.Learned a lot of material in the course that will help further my operations in operating
a crane. The instructor was well prepared and knew the laws and regulations pertaining to the course. (The Instructor) was very helpful in all aspects.
Wheelabrator Dan R.(What I liked most about the seminar was…) Good material.
Lufkin Industries Brian M.Inspections, types of cranes and components and tension (load) calculations for different scenarios.
Toro Millie S.(What I liked most about the seminar was...) All information is going to be used.
Keystone Steel & Wire Scott A.This course was very informative to me and the instructor was very good at his job.
Thank you for the information. I learned a lot of the do's and don'ts.
Crane Course for Operator and Rigging Training Personnel
Do you have so many operators within your facility that having an outside contractor come in to conduct all the operator training is not cost effective? Using an experienced operator to conduct training is a common practice in industry. Will that individual pass on any bad habits in the process?
Think back to your state sponsored road test for your driver’s license, do you still drive a motor vehicle as you did for the state examiner? Most people would have to say no. Habits both good and bad become a part of our day to day lives before we are even aware of them.
This crane course will give the potential trainers not only the requisite information but also instructional skills for presenting information before groups of people.
This overhead crane operator training course will use either the Cab and Floor Crane Operator Course #808 or the Floor Crane Operator Course #808A as desired.
These crane training courses cover all the OSHA/ASME requirements for overhead crane operation including the reasons behind the requirements. We begin with the fundamentals such as identification of major crane components and focuses on the safe and proper operation of the crane.
Course objectives
- Identify all major crane components
- Explain the function of major components
- Explain and use recommended hand signals
- Explain and apply all recommended safety procedures
- Perform all recommended operating procedures
- Correctly make precision lifts
- Understand crane control operations (AC or DC)
- Hands-on training
Course outline
- Major crane components
- Safety devices
- Recommended operating procedures
- Communications
- Safe operating practices
- Conduct a 20-minute training presentation
You will receive the following (Student Kit):
- (12) Workbooks
- (12) OSHA Guides
- (12) Rigging Handbooks
- (12) Pocket Safety Tips
- (12) Safety Recommendations
- Certificate of Training
Contact the Konecranes Crane Training Institute now for questions or special requests.