You are here

Overhead Crane Operator & Rigging Train-the-Trainer (Refresher) - 3 Days

Course number: 808TR
Length: 3 days
Price: $1225.00

This course is a 3 day refresher course for previously certified operator trainers from Konecranes. This course will use either the Cab and Floor Crane Operator Course #808 or the Floor Crane Operator Course #808A as desired.

These courses cover all the OSHA/ASME requirements for overhead crane operation including the reasons behind the requirements. They begin with the fundamentals such as identification of major crane components and focuses on the safe and proper operation of the crane.

*PRE-REQUISITE: 808T, 808TR or 808TRA completed within the last two (2) years.

Pick-up good information on cranes. (I) took hoists for granted until now.

Ford Michael G.

The instructor was very knowledgeable of our crane. I feel this is the proper way
to train both mechanical and operations on the use of the crane. I have learned more about the crane in this week than in the 7 years I have been at Venco. I recommend this course be an annual event.

Conoco PhillipsVenco Gerald G.

Good job.

Gerdau Ameristeel Bill N.

(What I liked most about the seminar was...) Plant tours.

Cami Automotive Larry S.

Small group - easier to learn material.

Clearwater Paper Brandon C.

Crane Course for Operator and Rigging Training Personnel

Do you have so many operators within your facility that having an outside contractor come in to conduct all the operator training is not cost effective? Using an experienced operator to conduct training is a common practice in industry. Will that individual pass on any bad habits in the process?

Think back to your state sponsored road test for your driver’s license, do you still drive a motor vehicle as you did for the state examiner? Most people would have to say no. Habits both good and bad become a part of our day to day lives before we are even aware of them.

This crane course will give the potential trainers not only the requisite information but also instructional skills for presenting information before groups of people.

This overhead crane operator training course will use either the Cab and Floor Crane Operator Course #808 or the Floor Crane Operator Course #808A as desired.

These crane training courses cover all the OSHA/ASME requirements for overhead crane operation including the reasons behind the requirements. We begin with the fundamentals such as identification of major crane components and focuses on the safe and proper operation of the crane.

Course objectives

  • Identify all major crane components
  • Explain the function of major components
  • Explain and use recommended hand signals
  • Explain and apply all recommended safety procedures
  • Perform all recommended operating procedures
  • Correctly make precision lifts
  • Understand crane control operations (AC or DC) - Rigging 800T course is also included
  • Hands-on training

Course outline

  • Major crane components
  • Safety devices
  • Recommended operating procedures
  • Communications
  • Safe operating practices
  • Conduct a 20-minute training presentation

You will receive the following (Student Kit):

  • (12) Workbooks
  • (12) OSHA Guides
  • (12) Rigging Handbooks
  • (12) Pocket Safety Tips
  • (12) Safety Recommendations
  • Certificate of Training

Contact the Konecranes Crane Training Institute now for questions or special requests.

Register Online

Milwaukee Konecranes Training Institute

September 4,2019
Register Online

Phoenix, AZ

September 4,2019
Register Online

Houston, TX

September 10,2019
Register Online

Pittsburgh, PA

September 10,2019
Register Online

Dayton, OH Area

September 16,2019
Register Online

Mobile, AL

September 17,2019
Register Online

Los Angeles Konecranes Training Institute

September 17,2019
Register Online

Milwaukee Konecranes Training Institute

October 8,2019
Register Online
Content bottom